Harbor Freight Tools 47996 Bedienungsanleitung PDF herunterladen (Seite 5)

Page 5SKU 47996

Maintenance

Replacing Batteries

1. Turn the Helmet over to expose the inside.

2. Remove the Battery Cover. Lift the right side of the battery cover and pop it out.

3. Remove two batteries from the battery compartment.

4. Place both new batteries negative side (left) into the battery compartment.

The batteries should be completely clean of grease and dirt.

5. Replace the Battery Compartment Cover, left side first, then push in the right side until

it snaps into place.

General

1. Use a clean, soft cloth to clean the Lens Filter. Do not use water or cleaning liquids.

2. Store the helmet in a cool and dry location.

Shade Control

On / Off Button

AAA Battery Compartment

Battery Compartment Cover

WARNING: This Helmet does not provide protection for LASER AND OXYHYDROGEN

welding.

1. Verify that the batteries are good.

2. Turn the helmet over and adjust the Shade Knob to the desired shade (9 ~ 13).

3. Push the Switch Button to turn the lens on and open the window.

4. Adjust the helmet Side Knobs for a proper fit. Tighten the Lens Clamp Screws.

5. Put on a pair of safety glasses first, then the helmet.

6. While looking to one side, strike an arc briefly (see # 6 above).

Check to see if the welding filter lens went dark. If it did, the auto-darkening function is

working. Continue arc welding. When finished, the lens filter will turn off automatically.

1 2 3 4 5 6 7

Keine Kommentare

Harbor Freight Tools 47996 Bedienungsanleitung Seite 5