Harbor-freight-tools 42976 Bedienungsanleitung

12 SpeedDrill / Mill MachineModel 42976 42976 42976 42976 42976Assembly & Operating InstructionsCopyright 2000 by Harbor Freight Tools®. All Ri

Preparing for Milling1. Loosen the Chuck Travel Limit Screw (#6).2. Install the cutting bit needed to perform the intended milling operation.3. Using

The machine doesn’t run when the power switch is turned ON.1. The power cord is not plugged in.2. The chuck spindle may be bound by the workpiece, cut

Page 12 SKU # 42976PLEASE READ THE FOLLOWING CAREFULLYTHE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL ASA REFERENC

Page 13 SKU # 42976DRILL / MILL MACHINE, TABLE AND BASE PARTS LISTPlease refer to Parts Diagram on Page 14.P/N Description Quantity 1 Base (Not

Page 14 SKU # 42976#42976 DRILL / MILL MACHINE, TABLE AND BASE PARTS DIAGRAMPlease refer to Parts List on Page 13.Note: Parts for optional Stand are

Page 15 SKU # 42976#42976 DRILL / MILL MACHINE, HEAD PARTS LISTPlease refer to Parts Diagram on Page 16P/N Description Quantity 68 Body 1 69 Scre

Page 16 SKU # 42976#42976 DRILL / MILL MACHINE, HEAD PARTS DIAGRAMPlease refer to Parts List on Page 15.

SPECIFICATIONSINCLUDED ACCESSORIES4, 5 and 6mm Hex WrenchesDrift PinDrill ChuckChuck KeyStand AssemblyPrecision 0-70O viseFEATURES1. This machine may

SAFETY WARNING & CAUTIONSREAD ALL INSTRUCTIONS BEFORE USING THIS TOOL!1. KEEP WORK AREA CLEAN. Cluttered areas invite injuries.2. OBSERVE WORK ARE

Page 4 SKU # 4297614. STAY ALERT. Watch what you are doing. Do not operate this machine when you are tired.15. DO NOT OPERATE THIS MACHINE WHILE UNDER

FEATURES AND CONTROLS OF THE #42976 DRILL / MILL MACHINEPage 5 SKU # 429761. Column2. Gear Strip3. Head Crank4. Vertical Head Lock5. Chuck Feed L

Page 6 SKU # 42976UNPACKING AND INSTALLATION1. Remove protective crating and skids carefully. In the event of damage in transit, contact Harbor Freigh

Page 7 SKU # 42976EXTENSION CORDSNote: Performance of this tool may vary depending on variations in local line voltage.Extension cord usage may also a

Page 8 SKU # 42976BASIC OPERATIONFor reference numbers mentioned in these instructions, please see page 5.WARNING: Unplug the drill from its power sou

Preparing for Drilling1. The Chuck (#9) is installed on the Spindle (#10) using a Morris Taper. This is a self-centering design.2. Rotate the Chuck Fi