Harbor Freight Tools 31849 Bedienungsanleitung

31849ASSEMBLY & OPERATING INSTRUCTIONS7” RABBETINGJOINTER WITH STAND3491 Mission Oaks Blvd., Camarillo, CA 93011Visit our Web Site at www.harborfr

Step 4) If the knife is not aligned at one or both sides, loosen Bolts (60) which hold the Knife Lock Bar(61). Use a knife setting gauge (not include

Step 8) Secure the rear table in position and remove the feeler gauge.Step 9) Lower the infeed table and place a straight edge on the outfeed table so

Turning the Jointer ON and OFFStep 1) To turn the Jointer ON, press down on the green button on top.Step 2) To turn OFF the Jointer, press down the re

UnpackingUNPACK AND CHECK CONTENTSWhen unpacking your Jointer with Stand check to make sure the following parts are included. If any parts aremissing

Parts List - Jointer AssemblyPart # Description Quantity Part # Description Quantity1 Outfeed Table 1 36 Spring 12 Bearing Housing 1 37 Spring Knob 13

Stand Assembly DiagramEach of the Part Numbers below correspond to the Stand Assembly and has the suffix “A” - see Parts List onPage 13.#31849 P

Jointer Assembly Diagram - See Parts List on Page 14#31849 Page 16

WhiteWhiteBlackBlackWiring Diagram#31849 Page 17

THANK YOU for choosing a HARBOR FREIGHT TOOLS product. For future reference, please complete theowner’s record below:Model______________ Serial No.__

Work AreaTO AVOID RISK OF PERSONAL INJURY, EQUIPMENT DAMAGE, FIRE AND SHOCK, MAKE SURE YOURWORK AREA IS:Free of damp, wet or rainy conditions.Free of

Grounding/Voltage WarningCommon household current is 110-120 volts. As long as the outlet used with the tool is rated from 110-120Vthere will be no c

The StandStep 1) Attach the Front Side Plate (#16A) to both of the Side Link Plates (part #19A).Insert two Screws (#17A) through Front Side Plate and

Step 9) Attach the Tapping Plate (#25A) with Right and LeftTapping Fenders (#23A & #27A) to the Left ProtectingPlate (#26A). Insert the Screws (#

Cutterhead GuardWarning: Beware of sharp blade when installing the Cutterhead Guard.Step 1) Inside of the Spring Knob (#37) there is a Spring (#36) w

Step 2) Flip the square jib so that its end sits against the flat part of the Plate (18)-see Figure 7.Step 3) Using an Allen Wrench, attach this assem

Fence AdjustmentsThe Fence (part #11) is assembled to the front of the Infeed Table (#33). The Fence can be moved across theTable and can be tilted 4