Harbor Freight Tools Manual Tire Changer Handbuch PDF herunterladen (Seite 8)

Page 8 For technical questions, please call 1-888-866-5797. Item 62317

Mounting Tire Onto Rim

1. Set rim on Center Post and lock into

place using the Spider Post and

Post Cap (if not already done).

2. Set tire on rim and push down

on opposite ends of the tire.

See Figure O, below.

Figure O

NOTE: Be sure to apply bead

lubricant before tire mounting.

3. Stick Mounting/Demounting Bar through

tire (with flat edge facing down) to

help wedge bead back behind rim.

4. Push down on tire with free hand as

you work bead behind rim. If needed

push Bar along Center Post for added

leverage. See Figure P, below.

Figure P

5. Once inner side of tire is mounted

to rim, push down on tire again until

one side of outer bead is under rim.

6. Remove Bar and switch ends, so that

hook side is pressed against bead.

7. Push Bar down so that hook

end wedges bead under rim.

See Figure Q, below.

Figure Q

NOTE: Be sure to apply more

bead lubricant, if needed.

8. Continue to work around rim until

tire mounts over edge of bead.

IMPORTANT: If tire bead starts to seat

during mounting, the tire will need to

stretch more and will be more difficult to

mount. To prevent this, push down on tire

with your free hand so it doesn’t seat on

the upper edge of rim during mounting.

1 2 3 4 5 6 7 8 9 10 11 12

Keine Kommentare

Harbor Freight Tools Manual Tire Changer Handbuch Seite 8